Stadiametric Rangefinder - Pulsar TRAIL Manual De Instrucciones

Connection status
Wi-Fi is off
Wi-Fi activated by the user,
Wi-Fi in the sight is being activated
Wi-Fi is on, no connection with
sight
Wi-Fi is on, sight connected
Your sight is detected by an external sight as "TRAIL_XXXX", where
XXXX – is the last four digits of sight's serial number».
After a password is generated on an external appliance (please refer
to the menu option "Wi-Fi setup" of the section "Main menu functions"
of this user manual) and connection is established, the icon
status bar changes to
display of external sight starts automatically.
17

STADIAMETRIC RANGEFINDER

Thermal sights are equipped with a stadiametric rangefinder which
allows the user to estimate approximate distance to an object of known
size.
To select option "stadiametric rangefinder" enter the hot menu a
=
short press of the M (4) button and select icon
DOWN buttons.
You will see on the display: measurement bars, icons of three
=
reference objects and respective distances for the three objects.
There are three pre-set reference objects:
=
- Hare – height 0.3 m
- Wild boar – height 0.7 m
- Deer – height 1.7 m
= Move the lower fixed bar under
the object being ranged and,
while pressing the UP and
DOWN buttons, move the upper
horizontal bar relative to the lower
fixed bar until the object fits
entirely between the two bars.
The distance to the object is automatically recalculated as you
move the upper line.
27
Status bar indication
; transmission of the video signal to the
with UP and
160m
66m
28m
If ranging does not take place within 10 seconds, the information
=
disappears from the display.
To select the unit of measurement (metres or yards), go to the
=
respective menu option.
Before it appears on the display, a measured distance value is
=
rounded up to 5 m for larger values, and rounded down to 1 m for
smaller values.
Exit rangefinder mode with a short press of the M button or wait 10
=
seconds to exit automatically.
18
FUNCTION DISPLAY OFF
The DISPLAY OFF function activates stand-by mode which allows the
sight to be quickly powered on.
in the
Operating scenarios for the «Display off» function
Scenario 1. The sight is turned off. Turn the sight on and activate
«Display off».
Turn on the sight on with a short press of the ON button.
Activate «Display off» with a long press of the ON button. Message
"Display off" with countdown appears.
Release the ON button.
Scenario 2. «Display off» is on, the sight needs to be turned off.
Hold down the ON button. Message "Display off" with countdown
appears (1,2,3)
Hold down the ON button until the sight turns off (the sight turns off
after 1 is reached).
19
FUNCTION PiP
PiP ("Picture in Picture") allows you to see a zoomed image
simultaneously with the main image in a dedicated window.
Turn on/off the PiP function with a long press of the DOWN (8) button.
Change zoom ratio in the PiP window with a short press of the DOWN
button.
00:03
Display off
28