Control Panel; Batch Function - ratiotec RAPIDCOUNT B 20 Manual Del Usuario

[EN]

Control panel

ADD
Operation
Connect the mains cable and switch on the machine. The machine performs a self-test. To avoid interruptions,
sort out damaged or soiled banknotes and remove paper clips and adhesive tape. Place a sorted stack of bank-
notes (e.g. only 20Euro banknotes) in the center of the banknote feeder. The machine automatically starts the
counting process and shows the quantity of counted banknotes. The automatic start is activated by default.
AUTO is shown on the display. When holding START/RESET, you can deactivate the automatic start. The counting
process can now be started manually by pressing START/RESET.

Batch function

By using the Batch function it is possible to count a preset number of banknotes (e.g. 10 pcs) from a bigger
stack of banknotes, for instance to form a banknote bundle. You can choose between preset batch quantities
of 100/50/20/10/--- by pressing the BAT key. For any other batch quantity between 1 and 100, press the keys +
or – to raise or lower the quantity in units, or hold the key down to change the quantity quicklier. Now start the
counting process by placing a stack of banknotes in the feeder. When the quantity of the batch is reached during
a counting process, the device will stop. After removing the banknotes from the stacker, the machine will auto-
matically start a new counting process if there are still banknotes in the feeder. Choose --- by pressing the BATCH
key to deactivate the Batch function.
4
BATCH
START/
RESET
UV MG
1. +/-: Choose a batch amount.
2. BATCH: Choose a preset batch amount.
3. START/RESET: Start the counting process when
automatic start is deactivated. Delete the counting
result in Addition mode. Hold for a few seconds:
Activate/Deactivate the automatic start.
4. MG: Activate/Deactivate detection of MG features
(only B 40).
5.
UV: Activate/Deactivate detection of UV features.
6. ADD: Activate/Deactivate the Addition mode.