Philips Respironics Amara Instrucciones De Uso página 4

Removing the Mask
Disconnect the headgear clips and pull over the top of your head
(Figure 6).
Disassembly of the Mask
1. Headgear - Remove from the forehead pad support and
headgear clips.
2. Forehead pad - Slide off the track of the forehead pad support
(Figure 7).
3. Mask Cushion - Grasp and pull it off the mask frame
(Figure 8).
Assembly of the Mask
1. Forehead pad - Slide on the track of the forehead pad support.
2. Mask Cushion - Use your thumbs to press the cushion past
the retaining tabs on the elbow and press into place (Figure 9).
3. Headgear - Thread the top straps through the forehead pad
support, and the bottom straps through the headgear clips.
Push the headgear clips onto the mask frame.
Tubing Quick Release
The elbow is equipped with a quick release swivel for the CPAP
tubing. Simply pull on the swivel with the tubing attached and the
tubing will release from the entrainment elbow.
Specifications
Warning: The technical specifications of the mask are provided
for your healthcare professional to determine if it is compatible
with your CPAP or bi-level therapy device. If used outside these
specifications, or if used with incompatible devices, the mask
may be uncomfortable, the seal of the mask may not be effective,
optimum therapy may not be achieved, and leak, or variation in
the rate of leak, may affect device function. The pressure flow
curve shown below is an approximation of expected
performance. Exact measurements may vary.
Pressure Flow Curve
90
80
70
60
50
40
30
20
10
0
0 5
4
Pressure Flow Curve
Amara Full Face Mask
10 15 20
Pressure cm H O
2
25 30
Figure 6
Figure 7
Figure 8
Figure 9