Trim Installation - Eaton Cooper Lighting PORTFOLIO LSRWM8AX Serie Instrucciones De Instalación

Installation Instructions – LSRWM8AX* Commercial LED Rough-In
INSTALLATION
N otee: LED and Trim assembly to be installed only after
cylinder is installed.
Wall Mount Section
1. Install wall mounting plate to splice box using splice
box hardware (provided by others) and tighten to 17 IN/
LBS torque when using 8-32 screw (Figure 1.).
2. Wire unit per appropriate Wiring Diagram (refer to
electrical section).
3. Attach rear wall mount tether to splice box mounting
screw.
4. Mount cylinder housing assembly to wall by tightening
screws on top and bottom of arm base to 17 IN/LBS
torque to engage mounting plate.
5. Installer must apply silicone compound around entire
perimeter of the mounting arm where it mates to the
mounting surface.

Trim Installation

1. Remove reflector from protective packaging. Remove
plastic trim ring and discard. Remove LED engine from
protective packaging (Figure 2.).
2. Insert lens onto white reflector (Figure 3.).
3. Place LED Engine into Lower trim. Align trim slots with
engine screw holes (Figure 4.).
Figure 1.
LED Engine
Lens
Lower Trim
Lower Trim
Figure 2.
Lower Trim Assembly
2
Torsion
Springs
Installation Instructions – LSRWM8AX* Commercial LED Rough-In
705476BINS ADP142627 www.eaton.com
Figure 3.
Figure 4.
Figure 5.
Tether Hook
Tether Bracket
Figure 6.
Align