Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LDSQ4/LDSQ6 Commercial Recessed LED Rough-In
INSTALLATION
Rough-In Section
1.
Install fixture into ceiling cavity using 1/2˝ electrical
conduit. Use 3/4˝ channel, 1-1/2˝ channel, 1/8˝ x 1/2˝
bar stock, or T-bar fasteners as mounting rails (furnished
by others) by inserting the through hanger brackets at
both sides (Figure 1.).
2.
Adjust hanger adjustment screws so bottom of is flush
with finished ceiling line. Hanger bracket is reversible
for total adjustment of 5˝.
3.
(Height): Square neck can also be adjusted by loosening
the 4 thumbscrews and adjusting such that the neck is
flush with the ceiling. Once desired height is achieved,
tighten thumb screws (Figure 2.).
4.
(Rotation): If rotation of the square neck is required,
loosen 2 thumbscrews. Rotate the square neck to
the desired position. Tighten thumbscrews upon
completion (Figure 2.).
5.
Remove one of the junction box covers. Connect supply
lead wires to lead wires of driver as per Wiring Diagram
and in accordance with your local electrical code(s) or
N.E.C.
Trim Installation
1.
Place end of flexible conduit through frame opening
in ceiling exposing upper portion of quick disconnect
(Figure 4.).
2.
Remove LED engine from protective packaging. Align
upper and lower portion of Powerplug® Luminaire
Disconnect and push together. Make sure locking lever
hook of Powerplug® Lumaire Disconnect is latched
(Figure 5.).
Fixture Attachment Method
Figure 1.
2
Powerplug®
Luminaire Disconnect
Installation Instructions – LDSQ4/LDSQ6 Commercial Recessed LED Rough-In
705077INS
Height Adjustment
Thumb Screws
Rotational
Adjustment
Thumb Screws
Figure 2.
Powerplug®
Luminaire
Disconnect
Thumb
Screws
Lower
Trim
Figure 3.
Figure 4.
Figure 5.
ADP140589 www.eaton.com
Junction
Box Cover
LED
Engine
Lens
Torsion
Springs
Publicidad
Tabla de contenido
