Electrical Connection; Wiring Diagrams - Eaton Cooper Lighting PORTFOLIO LSRWM8AX Serie Instrucciones De Instalación

4. Using provided thumb screws, securely attach lower
trim to LED Engine. Align Power Plug from LED Engine
with cylinder housing connector and push together.
Electrical connection has now been made (Figure 5.).
5. Connect tether to module (Figure 6.).
6. Install the LED Engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 7 .).
Cleaning
To Clean Trims:
1. Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
2. Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3. Rinse with clean water and dry with soft, clean, dry
lint-free cloth.

Electrical Connection

CAUTION
Make certain no bare wires are exposed outside of wire nut
connectors.
1. Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C (Figure 8.).
2. Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using
properly sized wire nuts. Be careful not to leave any
bare conductors outside of the wire nut connectors.
3. Connect white to white, black to black, and green (from
electrical service) on the supply side to the bare copper
wire in the cylinder housing assembly.

Wiring Diagrams

1. For DE010 Driver
(9000, 8000, 6500, 6000, 5000, 4000 LUMENS)
BLACK(LINE)
120V-277V
WHITE(N)
GREEN
BLACK(LINE)
120V-277V
TERMINAL
BLOCK
WHITE(N)
GREEN (GND)
GREEN
WHITE(N)
BLACK(LINE)
120V-277V
Installation Instructions – LSRWM8AX* Commercial LED Rough-In
BLACK(-)
LED
RED(+)
DRIVER #1
4 5 6
CONNECTOR
FEMALE
1 2 3
RED W/WHITE
STRIPE (+)
LED
BLACK W/WHITE STRIPE (-)
DRIVER #2
Installation Instructions – LSRWM8AX* Commercial LED Rough-In
705476BINS ADP142627 www.eaton.com
Figure 7.
Figure 8.
2. For DE010 Driver (Below 3000 LUMENS)
BLACK(LINE) BLACK(LINE)
WHITE WHITE
(NEUTRAL) (NEUTRAL) 0-10V DIMMING
DRIVER
GREEN
BLACK
BLACK
RED
LED
PURPLE
RED
GRAY
MODULE WIRING
DIAGRAM
0-10V DIMMING
FIELD INSTALL
3