Trim Installation - Eaton Cooper Lighting PORTFOLIO LCRWM8AX Instrucciones De Instalación

Installation Instructions – LCRWM8AX* Commercial LED Rough-In
INSTALLATION
Wall Mount Section
1. Install wall mounting plate to splice box. Make electrical
connections to outlet box. (see "Electrical Connection"
section).
2. Mount cylinder housing assembly to wall by tightening
screws on top and bottom of arm base to engage
mounting plate (Figure 1.).
3. Attach rear wall mount tether to splice box.
Screw
Wall
Mounting
Plate
Screw
Figure 1.

Trim Installation

1. Remove reflector from protective packaging. Remove
plastic trim ring and discard. Remove LED engine from
protective packaging (Figure 2.).
2. Insert lens onto white reflector (Figure 3.).
3. Place LED Engine into Lower trim. Align trim slots with
engine screw holes (Figure 4.).
4. Using provided thumb screws, securely attach lower
trim to LED Engine. Align Power Plug from LED Engine
with cylinder housing connector and push together.
Electrical connection has now been made (Figure 5.).
5. Connect tether to module (Figure 6.).
LED Engine
Lens
Lower Trim
Lower Trim
Figure 2.
Lower Trim Assembly
2
Torsion
Springs
Installation Instructions – LCRWM8AX* Commercial LED Rough-In
705476BINS ADP140596 www.eaton.com
Figure 3.
Figure 4.
Figure 5.
Tether Hook
Tether Bracket
Figure 6.
Align