Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TRIM Installation
1.
Insert trim into the opening of the LED module until it
is flush against the ceiling (see figure 5).
2.
The soft focus lens accessory cannot be used with
trims with lenses.
Wall Wash Option
1.
For a wall wash application, the Retrofit module must
be installed in the proper orientation.
2. For proper wall wash installation (see Figure 7).
Line (3) tabs
up to (3) slots
Lift holder and lens to optic twist
counter clockwise until secured
Figure 6
Light Output Direction
Figure 7
Lever Nut
Figure 8
Angle of Wall
Wash Lens
Matches Angle
of Optic
Ground
Lever Nut
Installation Instructions – LDRT2 LED Retrofit www.eaton.com
Installation Instructions – LDRT2 LED Retrofit
Electrical Connection
CAUTION
Make certain no bare wires are exposed outside of wire nut
connectors.
1.
Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
junction box (located on the plasterframe). Supply wire
insulation must be rated for at least 90°C. The junction
box is rated for a maximum of 4 No. 12 AWG Branch
Circuit conductors and is also suitable for at least 90°C.
2.
Remove junction box cover (Figure 8).
3.
Remove appropriate round pryout and connect conduit
to junction box with proper connector (not included).
4.
Connect supply lead wires to junction box lead wires
(line, neutral and ground) in the fixture using the
provided lever nut connectors. Be careful not to
leave any bare conductors outside of the lever nut
connectors.
5.
Lift the orange tab on the lever nut to disengage the
wire and close to secure the wire in place. (Figure 9).
6.
Connect white to white, black to black, and green
(from electrical service) on the supply side to the bare
copper wire in the junction box. Place all excess wiring
and connections into the junction box and replace the
cover. Place all connections and excess wiring into the
junction box and replace cover.
Lever Closed
Close Lever To
Secure Wire
Figure 9
Lever Open
Open Lever To
Release Or Insert
Wire
3
Publicidad
Tabla de contenido
