Adjusting The Belt Tension - Husky C602H Guía De Uso Y Cuidado

Maintenance (continued)

ADJUSTING THE BELT TENSION

NOTICE: Once the engine pulley has been moved from its factory
set location, the grooves of the flywheel and pulley must be aligned
to within 1/16 in. (1.6 mm) to prevent excessive belt wear. Verify the
alignment by performing the MOTOR PULLY/FLYWEEL ALIGNMENT on
the following page.
□
Slide the motor into the original position, and
line the motor up with the mark made earlier on
the saddle.
□
Tighten the two outside motor mounting screws
enough to hold the motor in place for checking
the pulley and flywheel alignment.
□
The belt should deflect 3/16 in. (4.8 mm) at
midway between the pulley and the flywheel
when a five-pound (2.26 kg.) weight is applied at
the midway point.
□
When proper belt tension is achieved, tighten all
four motor mounting screws. Torque to 20-25
ft-lbs (27.1–33.9 Nm).
22
Deflection