Adjusting The Belt Tension - Husky C304H Guía De Uso Y Cuidado

Maintenance (continued)

ADJUSTING THE BELT TENSION

NOTE: Once the engine pulley has been moved from its
factory set location, the groves of the flywheel and pulley
must be aligned to within 1/16 in. (1.6 mm) to prevent
excessive belt wear. Verify the alignment by performing the
following pulley and flywheel alignment.
□
Slide the motor into the original position, line
the motor up with the mark made earlier on the
saddle.
□
Tighten the two outside motor mounting screws
enough to hold the motor in place for checking
the pulley and flywheel alignment.
□
The belt should deflect 1/2 in. (12.7 mm) at
midway between the pulley and the flywheel
when a ten-pound (4.54 kg) weight is applied at
the midway point.
□
When proper belt tension is achieved, tighten all
motor mounting screws. Torque to 15-20 ft-lbs.
(20-27 Nm).
21
Please contact 1-888-43-HUSKY for further assistance.
Deflection
HUSKYTOOLS.com