Setting Up The Torch Body; Connecting The Plasma Cutting Torch - Abicor Binzel ABICUT 25K Instructivo De Servicio

ABICUT 25K/45/75

6.1 Setting up the torch body

NOTICE
• Only use original ABICOR BINZEL wear parts.
• With the ABICUT 75, the selection of the swirl ring (contact or HF) must match the
ignition type of the plasma power source.
• Selecting the plasma nozzle
 Tab. 3 Selection of plasma nozzle on page EN-6
Set up the torch necks according to the following figure. Make sure the wear parts are correctly
assigned and fit securely:
ABICUT 25K
ABICUT 45
ABICUT 75
ABICUT 75 HF
Version
1 Spacer spring
2 Spacer guard
3 Protective cap
4 Pressure spring
Fig. 2 Setting up the torch body with standard wear parts

6.2 Connecting the plasma cutting torch

NOTICE
• Make sure the connections are properly assigned and tightened.
• Since the plasma nozzle cannot be protected against direct contact for technical reasons,
the plasma cutting power source must fulfil the requirements of EN 60974-7, point 7.4.2.
• The plasma cutting torch in connection with the plasma power source must conform to
EN 60974-10.
• The plasma power source must also conform to EN 60974-1.
• The plasma power source and cutting torch must have the same type of ignition (contact
or HF) and the same output power (rated current and corresponding duty cycle).
 Tab. 2 General torch data (EN 60974-7) on page EN-5
BAL.0173 • 2018-09-28
1 2 3 4
5 Nozzle
6 Swirl ring
7 Electrode
8 Cooling tube
5 6 7 8
9 Torch neck
10 Switch key wrench
6 Putting into operation
9 10
EN - 9