Putting Into Operation; Setting Up The Torch - Abicor Binzel ABIMIG XX0 Instructivo De Servicio

®
ABIMIG XX0/XX5

5 Putting into operation

5.1 Setting up the torch

DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the gas supply.
• Disconnect all electrical connections.
DANGER
Risk of injury and machine damage when handled by
unauthorised persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if the unit is handled by unauthorised persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany see TRBS 1203).
NOTICE
• Please take note of the following instructions:
 3 Product description auf Seite EN-4
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
The torches are delivered fully equipped. If the torch is not ready for welding,
the following steps are necessary:
Equip the torch necks according to the following figures:
5 Putting into operation
EN - 9