Oakley KILL SWITCH Manual Del Usuario página 4

4 | OAKLEY KILL SWITCH INSTRUCTION MANUAL
™
TO ADJUST THE TIME AND DATE FOR SUBSEQUENT SETTINGS, USE THESE SHORT PROCEDURES:
TO SET THE TIME
1. Unscrew the crown from the case and pull it out to the
second click position (b).
2. Turn the crown until you reach the correct time.
3. Push the crown back in. Gently turn the crown
clockwise until it screws back into the case. Be
careful not to over-tighten the crown, as this will
damage the mechanism.
TO SET THE DATE
If the current time is between 9:30 PM and midnight, do
not use this short procedure.
1. Unscrew the crown from the case and pull it out to the
first click position (a).
2. Turn the crown clockwise until you reach the correct
date.
3. Push the crown back in. Gently turn the crown
clockwise until it screws back into the case. Be
careful not to over-tighten the crown, as this will
damage the mechanism.
Setting the date too quickly may result in the incorrect
date being displayed. To restore synchronization,
gradually turn the crown to go through the range of
date settings (from 1 to 31) when performing the
instructions above.
CROWN
b
a
SECOND HAND
DATE
You can change the bezel quickly and easily by doing
the following:
TO REMOVE THE BEZEL
1. Without touching the bezel, press both pushers at
the same time. The bezel will release from the case.
2. Lift the bezel off the case.
OAKLEY KILL SWITCH INSTRUCTION MANUAL | 5
™
CHANGING THE BEZEL