Power Saving Mode; Battery Replacement - Oakley KILL SWITCH Manual Del Usuario

6 | OAKLEY KILL SWITCH INSTRUCTION MANUAL
™
CHANGING THE BEZEL
TO INSTALL THE BEZEL
1. Gently place the bezel in position. Be sure it is placed
correctly and precisely.
2. Place your thumb and forefinger on the top surface
of the bezel, near the two pushers. Apply pressure
simultaneously with both fingers. The bezel will lock
into position.
When the timepiece is not in use, the battery life can be prolonged by pulling the crown out to the second click position
(b). This will stop the hands and reduce power consumption.
The miniature battery that powers the timepiece is designed to last approximately five years. However, because the
battery is inserted at the factory for extensive performance checks, its actual life, once in your possession, may be less.
The timepiece has a system that indicates when battery power is low. When the second-counting hand advances at
four-second intervals, the battery should be replaced.
Battery replacement may be performed only by an Authorized Oakley Service Center. Any attempt to open the watch
case by persons other than Authorized Oakley Service Professionals will void the product warranty.
Within the United States, call Oakley global headquarters at 1-800-403-7449 to find an Authorized Oakley Timepiece
Service Professional near you. Customers outside the United States should contact their local Authorized Oakley
Timepiece Dealer or visit the Oakley website at www.oakley.com for the number of the nearest Oakley distributor.
OAKLEY KILL SWITCH INSTRUCTION MANUAL | 7
™

POWER SAVING MODE

BATTERY REPLACEMENT