Operating And Display Elements; Installation Manual - MTD H15 Manual Del Usaurio

Operating manual
Do not fill up with fuel
of specification E85!
Ejected objects and
rotating parts may
cause serious injuries!
Risk of injury from
rotating parts!
Keep hands and feet
away from rotating
parts.
Beware of hot sur-
faces!
Keep fire away from
the fuel tank!
Petrol/Oil!
Always use clean and
fresh lead-free petrol
for mixing petrol.
Use only authorised
oil according to the
operating manual
for mixing petrol.
Maximum rpm.
Do not let the unit
run more quickly than
the maximum rpm.
Ignition switch
On /run/start
Ignition switch
Off/stop
Choke settings
Choke position
Operating position
Ensure that these symbols on the
unit are always in a legible state.
Replace damaged or illegible
symbols.
Symbols used in this manual
The following symbols are used
in this manual:
Danger
They refer to dangers which are
connected with the described
activity and which may result
in injury.
Caution
They refer to dangers which are
connected with the described
activity and which may result
in damage to property.
Note
Indicates important information and
application tips.
Operating and display
elements
Caution.
Damage to the appliance
This first describes the control and
display elements. Do not execute
any of the functions yet!
Fig. 1
1 Exhaust cover
2 Spark plug
3 Starter handle
4 Tank cap
5 Intake pump/primer
6 Choke lever
7 Air filter cover
8 Hand grip
9 Upper drive shaft
10 Shaft coupling
11 Lower drive shaft
12 Cutting attachment cover
13 Line cutting blade
14 Line spool
15 Gearbox
16 Shoulder belt holder
17 Throttle lock
18 Throttle
19 Ignition switch
20 Throttle grip
21 Cutting blade with cutting
attachment cover *
22 Retaining bar *
23 Socket wrench *
* depending on model

Installation manual

Danger
Risk of injury from engine being
started unintentionally.
Protect yourself from injury.
Before working on the engine:
– Switch off the engine.
– Wait until all moving parts have
come to standstill; the engine
must have cooled down.
– Remove spark-plug terminal.
Disposal instructions
Dispose of packaging remnants,
old units, etc., in accordance with
local regulations.
Installing and adjusting
the hand grip
Fig. 2a
Remove hand grip. To do this,

loosen the 4 screws.
Fit the anti-vibration rubber pad

on the shaft.
Place the hand grip from above

onto the anti-vibration pad.
Align the holes of the lower

retention plate with the screws in
the hand grip. Screw in the 4
screws. Do not tighten yet! Hold
the unit in the operating position
(Fig. 12) and move the hand grip
into the position which offers you
the best grip.
Tighten the 4 screws until the

hand grip is secure.
Installing/removing the lower
drive shaft
Fig. 2b
Installation
Remove protective cap (optional)

from the shaft coupling and lower
drive shaft.
Turn screw handle (1) on the shaft

coupling (2) anti-clockwise
to open the shaft coupling.
Press release button (3)

on the lower drive shaft and push
the shaft into the shaft coupling
until the release button engages
in the retaining hole (4).
English
7