Cleaning And Maintenance; Technical Specifications - ResMed Remote Alarm II Manual Del Usuario

Cleaning and maintenance

The Remote Alarm can be cleaned using an anti-bacterial
cleaning solution such as Mikrozid
non-dyed disposable cloth. For a full list of approved cleaning
solutions, refer to the Technical Specifications section.
Troubleshooting
Problem/possible cause
The LED does not turn on when connected to the
ventilator or when the Self-test button is pressed.
Batteries may not be
inserted or may be flat
The Remote Alarm detects a disconnect while the cable is
connected.
Poor connection
The Remote Alarm detects a disconnect while an alarm is
raised on the ventilator.
Poor connection
The second Remote Alarm is sounding an alarm with no
alarm raised on the ventilator.
Poor connection.
The Remote Alarm triggers a low battery alarm.
Batteries are flat.

Technical specifications

Operating temperature
Operating humidity
Operating altitude
Storage and transport
temperature
Storage and transport
humidity
Electromagnetic compatibility
Output volume
6
AF or CaviCide
®
Solution
Check that two AA batteries are
inserted correctly in the rear of the
alarm. If necessary, change the
batteries. If the problem persists,
contact your ResMed service agent.
Change the cable. If the problem
persists, change the Remote Alarm.
Change the cable. If the problem
persists, change the Remote Alarm.
Check that the connecting cable is
firmly plugged into the first Remote
Alarm and the rear of the ventilator.
If the problem persists, contact your
ResMed service agent.
Change the batteries.
+32°F to 104°F (0°C to +40°C)
10% to 95% non-condensing
Sea level to 10,000 ft (3,050 m).
-22°F to 158°F (-30°C to +70°C)
10% to 95% non-condensing
This product complies with
all applicable electromagnetic
compatibility requirements (EMC)
according to IEC60601-1-2:2007,
for residential, commercial and
light industry environments. The
electromagnetic compatibility tables
for these ResMed devices can be
found on www.resmed.com, on
the Products page under Service &
Support. Click on the PDF file for
your device.
55-90 dBa (as per ISO 3744:2010)
on a clean,
®