Cleaning And Maintenance - ResMed Air10 Manual Del Usuario

7 . Plug your device back into the power outlet.
The AirSense 10 / AirCurve 10 / Lumis device will briefly display the oximeter
software code, eg, SX123-4567 .
The S9 device will briefly display Oximeter enabled.
You are now ready to start therapy. For more information, refer to your device User
Guide.
Removing and returning the oximeter adapter and
SD card
1. Remove the sensor from your finger.
2. Unplug your device from the power outlet.
3. Press the release button/s on the side of the oximeter adapter and pull gently
to remove it from the device.
4. Pull the Xpod oximeter out of the oximeter port on the oximeter adapter.
5. Remove the finger sensor cable from the Xpod oximeter.
6. Open the SD card cover and push in the SD card to release it.
7 . Place the SD card in the protective folder and send it back to your care provider
together with the oximeter adapter and this User Guide.

Cleaning and maintenance

If you need to, wipe the outside of the oximeter adapter with a clean, dry cloth.
For instructions on how to clean the oximeter and its sensor, refer to the User
Guide supplied with those accessories.
English 3