Connecting The Shielding Gas - Abicor Binzel ABIDRIVE CW Manual Del Usuario

TIG cold wire feeder
5.2 Overview of connections and operating elements
1 2
18
17
16
Power supply
1
Power connection X4 Intermediate cable assembly
2
Plug socket (to X2)
3
Power supply connection X2
4
Control lead plug X3 Intermediate cable assembly
5
Wire feeder dial
6
Overview of connections and operating elements
Fig. 4

5.3 Connecting the shielding gas

 Fig. 4 Overview of connections and operating elements on page EN-9
NOTICE
• The valve of the shielding gas cylinder must be closed when the gas hose is installed.
• To ensure a tight connection between shielding gas hose and connection, the nut must be tightened
Carry out the following activities:
1 Connect shielding gas hose to gas connection (15).
2 Connect the shielding gas hose to the shielding gas cylinder.
This completes the connection of the shielding gas supply.
5.4 Connecting the coolant
NOTICE
• Applies to liquid-cooled welding torches only.
• Please also consult the operating instructions for the welding components, such as welding torch and
• Make sure that the coolant supply and return have been installed properly. Coolant supply = blue,
• Do not use deionized or demineralised water as coolant or for tightness and flow tests. This may
• For liquid-cooled welding torches, we recommend using the ABICOR BINZEL coolant of the
3 4
15
Timer / Feed dial
7
Program selection switch
8
Display
9
10 Timer / Pause dial
11 Central plug
12 Socket of control lead X1
completely using a spanner.
power source.
coolant return = red.
impair the useful life of your welding torch.
BTC series.
5 6 7
14 13
13 Coolant return
14 Coolant supply
15 Gas connection
16 Mains plug
17 Power switch
18 Gas safety valve (T 0.63)
5 Putting into operation
8
9
10
11
12
EN - 9