Mounting; Wlens Mounting - Panasonic AW-HE870E Manual Del Operador

Mounting

wLens mounting

p Use the 2/3˝ bayonet type lens (such as the
AW-LZ17MD9AG and AK-LZ20M85G), available as an
optional accessory.
Notes
p Use the AW-LZ17MD9AG lens when using the
camera mounted on the pan-tilt head AW-PH360.
Lenses other than the AW-LZ17MD9AG cannot be
used. Do not mount the camera on the AW-PH360
when the AK-LZ20M85G is installed.
The balance cannot be secured.
p Tighten the lens fixing ring knob securely to secure
the lens, and check that there is no unsteadiness in
the lens. Also check that there is no unsteadiness in
the hood.
p Use the lens extension cable AW-CA12T12A if your IRIS
cable is too short.
1. Rotate the lens fixing ring knob counterclockwise and
remove the lens mount cap.
2. Mount the lens on the camera and rotate the lens
fixing ring knob clockwise in order to fix the lens
securely.
3. Connect the IRIS cable to the IRIS connector on the
back panel of the camera.
The connection and installation should be done by qualified service personnel
or system installers. Refer any servicing to qualified service personnel.
When the pan-tilt head has been used
p Connect the remote cable of the lens to the LENS IF (1)
terminal on the pan-tilt head.
When the SDI card (AW-HHD870) is installed
without using the pan-tilt head
p Connect the remote cable of the lens to the
ZOOM/FOCUS terminal of the SDI card.
Remote (for zoom/focus control) cable
(When the pan-tilt head is used, connect this
cable to the pan-tilt head)
IRIS cable
- 17 (E) -
To lens I/F connector of pan-tilt head
Lens fixing
ring knob
To iris
connector
To the ZOOM/FOCUS
terminal when the SDI
card is installed without
using the pan-tilt head