How To Assemble; How To Use - Hamilton Beach 67800 Manual Del Usuario

How to Assemble

Read and follow instructions in "Know Your Juice Extractor—BEFORE FIRST USE."
1� Place separator on top of motor
base as shown on page 3.
2� Place cutter/strainer into separator
and gently push until firmly in place.
Once in place, the cutter/strainer
should spin easily.
3� Place cover on top of separator and
cutter/strainer.
4� Position the top of both safety
latches in place; then push in at
bottom to lock. Lock both sides.
DO NOT OPERATE UNIT UNTIL
SAFETY LATCHES ARE LOCKED�

How to Use

Laceration Hazard�
w WARNING
Never use fingers or utensils other than the food pusher to press food into food
chute. Food should be placed in food chute only when unit is operating. Food
can be continuously placed in food chute without having to turn off unit.
1� For more information, see "Juicing
Tips and Techniques."
2� Cut food into pieces to fit the food
chute.
3� Plug cord into 120-volt AC outlet.
4� Be sure a juice container and the
pulp bin are in place.
5� Push switch up to turn ON (I). The
unit will not turn on until safety
latches have been closed.
6� Place food in food chute and press
4
5� Put pulp bin in place. Slide top in
first, then bottom, and snap into
place.
6� Place a container in position under
juice spout.
NOTE: Check the pulp bin frequently.
It is important to empty the pulp bin
when full and to clean out the separator.
TO DISASSEMBLE: Unplug cord from
outlet. Unlock both safety latches by
pulling out top of latch. Remove cover;
then lift up separator with cutter/
strainer.
down gently and slowly with food
pusher.
7� When pulp bin is full, turn unit OFF
( ). It is very important to empty
the pulp bin when full. For best
performance, empty pulp bin and
clean cutter/strainer and separator
often.
8� When juicing is completed, or when
pulp bin or juice container need to
be emptied, turn unit OFF ( ) and
unplug from outlet. Immediately
wash cutter/strainer according to
instructions.