How To Assemble; How To Use - Hamilton Beach 67800 Manual De Usuario

840095503 ENv02:840095500 Ev00

How to Assemble

Read and follow instructions in "Know Your Juice Extractor—Before First Use."
1. Place separator on top of motor
base as shown on page 3.
2. Place cutter/strainer into separator
and gently push until firmly in place.
Once in place, the cutter/strainer
should spin easily.
3. Place cover on top of separator and
cutter/strainer.
4. Position the top of both safety
latches in place; then push in at
bottom to lock. Lock both sides.
DO NOT OPERATE UNIT UNTIL
SAFETY LATCHES ARE LOCKED.

How to Use

w WARNING
Laceration Hazard.
Never use fingers or utensils other than the food pusher as a food pusher. Food
should be placed in food chute only when unit is operating. Food can be continu-
ously placed in food chute without having to turn off unit.
1. For more information, see "Juicing
Tips and Techniques."
2. Cut food into pieces to fit the food
chute.
3. Plug cord into 120-volt AC outlet.
4. Be sure a juice container and the
pulp bin are in place.
5. Push switch up to turn on. The unit
will not turn on until safety latches
have been closed.
4
2/4/09 11:34 AM Page 4
5. Put pulp bin in place. Slide top in
first, then bottom, and snap into
place.
6. Place a container in position under
juice spout.
NOTE: Check the pulp bin frequently.
It is important to empty the pulp bin
when full and to clean out the separator.
6. Place food in food chute and press
down gently and slowly with food
pusher.
7. When pulp bin is full, turn unit off. It
is very important to empty the pulp
bin when full. For best performance,
empty pulp bin and clean cutter/
strainer and separator often.
8. When juicing is completed, or when
pulp bin or juice container need to
be emptied, turn unit off and unplug
from outlet. Immediately wash cut-
ter/strainer according to instructions.