Safety Rules; General Safety Rules - Promax RP-200 Manual Del Usario

USER'S MANUAL RP-200

2. SAFETY RULES

2.1 General safety rules

* Use this equipment connected only to devices or systems with their common at
ground potential or insulated from the mains.
* The AC adapter is a class I equipment, for safety reasons plug it to a supply line
with the corresponding ground terminal.
* This equipment can be used in Over-voltage Category I installations and Pollution
Degree 2 environments.
* The external DC charger can be used in Pollution Degree 1 environments and
only indoor.
* When using some of the following accessories use only the specified ones to
ensure safety:
Power cord
Mains power adapter
Rechargeable battery
* Observe all specified ratings both of supply and measurement.
* Remember that voltages higher than 60 V DC or 30 V AC rms are dangerous.
* Use this instrument under the specified environmental conditions.
* The user is only authorised to carry out the following maintenance operations:
Battery replacement.
On the Maintenance paragraph the proper instructions are given.
Any other change on the equipment should be carried out by qualified personnel.
* The negative of measurement is at ground potential.
* Do not obstruct the ventilation system.
* Use for the signal inputs/outputs, especially when working with high levels,
appropriate low radiation cables
* Follow the cleaning instructions described in the Maintenance paragraph.
08/2006 Page 3