Programming Procedure; Reading Out The Data On A Bid Chip - ROBBE POWER PEAK FN DUO POWER Manual Del Usaurio

POWER PEAK FUN DUO POWER
The programming menu disappears when you disconnect the BID chip; the screen then
reverts to the normal display.
7.2

PROGRAMMING PROCEDURE

The method of programming the BID chip parameters is identical to the method for set-
ting the parameters, as described in Chapter 6.2. The parameter to be changed is
selected using the 'SELECT' button; the flashing cursor indicates the variable value. The
value can then be increased using the 'INC' button, and decreased with the 'DEC' but-
ton. The procedure is described below, using battery type selection as an example.
--
'DEC' button'
'DEC' button'
The selection is stored. Use the 'SELECT' button to navigate to the next parameter, and
use the same procedure to enter the appropriate settings. The remaining programming
steps can now be carried out using the same method. Please take care to observe the
information supplied by the battery manufacturer when programming the BID chip para-
meters. The battery can be connected once you have programmed all the settings. Press
the 'MODE' button to select the desired mode of operation and start the process.
7.3

READING OUT THE DATA ON A BID CHIP

Connecting a BID chip to the charger changes the endless menu loop: it now includes
additional menu points which contain the battery data. Calling up this data gives you an
overview of the state of the battery. The following section shows that part of the menu
structure in which the data is read out; in the endless loop this area is located between
the input voltage display and the battery type select point. Press the 'SELECT' button to
move to the next display.
Operating instructions
The first step is to move to the programming menu
and select the BID chip programming point using
'INC' button
the 'SELECT' button. At this point you can select
one of the available battery types using the 'INC'
button to scroll forward and the 'DEC' button to
scroll back. This menu is not arranged in an end-
'INC' button
less loop; at either end-point you have to press the
opposite direction button ('INC' or 'DEC') again to
continue.
'SELECT' button
'SELECT' button
Input voltage display, the status indi-
cator 'R' flashes
Display of maximum charged capaci-
ty; the status indicator 'R' flashes
33
Order No.
8468