Charge / Discharge Processes With A Bid Chip; Terminating A Charge / Discharge Process - ROBBE POWER PEAK FN DUO POWER Manual Del Usaurio

POWER PEAK FUN DUO POWER
8. CHARGE / DISCHARGE PROCEDURES WITH BID CHIPS
Even during a charge / discharge process it is possible to optimise the parameters using
the 'SET' buttons. If you change a setting, the process continues to run with the new
values. You can check the values by calling up the individual working displays in turn
using the 'SELECT' button.
9.

TERMINATING A CHARGE / DISCHARGE PROCESS

At the end of a charge / discharge process you will hear a brief audible signal, and the
screen briefly displays the message 'READY'. This applies whether the termination is
automatic or manual (by operating the 'MODE' button, because - say - the battery is fully
charged).
Operating instructions
'SELECT' button
'SELECT' button
'SELECT' button
'SELECT' button
'SELECT' button
Once you have programmed all the settings on the
chip, the battery must be connected. The charge /
discharge process is initiated by selecting the
'MODE' button
desired mode of operation using the 'MODE' but-
ton.
The selected process - e.g. 'CHARGING' - is dis-
played briefly on the screen, then this display
scrolls to the right and off the screen, to be repla-
ced by the last activated working display. The flas-
hing status symbol indicates the current process;
in our example this is 'C' for charging.
Display of maximum discharged capa-
city; the status indicator 'R' flashes
Display of completed charge cycles;
the status indicator 'R' flashes
Date display; the status indicator 'R'
flashes
Display of momentary charge current (not
stored in the BID chip). This can be altered
using the 'SET' buttons. The cursor and sta-
tus indicator 'R' flash
Display of momentary discharge current (not
stored in the BID chip). This can be altered
using the 'SET' buttons. The cursor and sta-
tus indicator 'R' flash
Battery type display; the cursor and
status indicator 'R' flash
34
Order No.
8468