Pre-Operation Checklist; Connect Hose And Water Supply To Pump - Echo PW-3100 Manual Del Usaurio

Follow the steps below prior to using the machine every time.
1. Check to ensure the engine oil is at the proper level. Use SAE 10W30 Oil
2. Check the 2 handle knobs in the frame to ensure they are tight and will not
vibrate loose.
3. Add fuel to the gas tank. Be careful not to spill while filling and do not
overfill. We recommend using fuel with the lowest amount of ethanol
possible. 87 octane and up is suitable.
4. Connect and tighten the garden hose to the GHA (garden hose inlet)
connection.
5. Connect high pressure hose to the pump outlet. Connect the other end to
the spray gun.
** Water must be turned on prior to starting the washer, pull the
spray trigger to ensure water is moving the through the lines and out the
nozzle without any leaks before starting the unit.**
6. Review the safety guidelines in the manual prior to starting the unit. If you
have any issues operating the pressure washer, call our customer service
line.
• Failure to do so could cause the engine to seize if the oil is low or empty.
Connect Hose and Water Supply to Pump Before Starting
• Failure to do so will result in damaging the pump from overheating
and void the warranty.
16
NOTICE
lways check the level of the engine oil prior to starting
A
the washer. Level should be at about halfway up the sight
glass. If your unit does not have one, use the oil dipstick.
The level should be about halfway up the dipstick.
NOTICE
DO NOT start your pressure washer without the water
supply turned on.

PRE-OPERATION CHECKLIST