Fitting Your Headset - Plantronics DISCOVERY 610 Guia Del Usuario

FITTING YOUR HEADSET

*Neutral Position
*"Νεκρή" θέση
*Semleges pozíció
*Pozycja neutralna
*Poziţie neutră
*Нейтральное
положение
*Orta Konum
EN FITTING YOUR HEADSET
The headset comes with three soft gel ear tips
and an optional ear stabiliser. The medium sized
ear tip is installed for wearing on the right ear.
1. Twist the ear tip to the right for left ear
wearing.
2. Place the headset into your ear with the
elongated side of the ear tip pointing up and
forward.
If the fit is not comfortable, either too tight or too
loose, remove the ear tip from the headset by
turning the ear tip to the neutral* position and
pulling the ear tip away from the headset.
1. Next, select the ear tip size that fits most
comfortably in your ear.
2. Hold the ear tip with the elongated edge
pointing down and push the ear tip post into
the opening on the headset.
3. Twist the ear tip to the left for right ear
wearing or to the right for left ear wearing.
4. Place the headset into your ear with the
elongated side pointing up and forward.
USING THE OPTIONAL EAR STABILISER
The ear loop may be attached to the headset to
improve stability.
1. Remove the ear tip from the headset by
turning the ear tip to the centre or neutral
position* and pulling the ear tip away from
the headset.
2. Attach the stabiliser in-between the ear tip
and the headset.
3. Replace the ear tip.
17