Corrective Action; Inspection Log - MSA WORKMAN FP STRYDER 10144431 Instrucciones Para El Usuario

P/N 10145808
Step 1: I nspect the WORKMAN FP STRYDER labels to verify that they are present and legible. See Section 8 for the specific labels that should be
present and the information contained thereon. Check the Formal Inspection Log to be sure a Formal Inspection has been performed within
the last six months. If the Log does not indicate that a Formal Inspection has been performed within the last six months, or if any labels are
missing or illegible, remove the device from use and mark it as "UNUSABLE" until a Formal Inspection is performed by a competent person.
Step 2: C heck the auto close action of the button. Depress button with thumb, and ensure auto closing. If button fails these functional tests, return to
maintain from service.
Step 3: C heck for structural defects and corrosion. Verify that are no missing, loose screw or altered parts; that there are no cracks, deformations, or
excessive corrosion.
Step 4: I nspect the D-ring for deformation, fractures, cracks, corrosion, deep pitting, burrs, sharp edges, cuts, deep nicks, and evidence of excessive
heat or chemical exposures. Check the pin with screw for no deformation, fractures, cracks, corrosion, pitting and nicks. Verify the screw in
the pin tightly. If the screws which connected with pins are loose, remove the device from use and make It "UNUSABLE".
Step 5: I nspect the load indicating D-ring connector for activation. If the device has been exposed to a fall arrest force the window will be deformed,
remove the device from use and make it "UNUSABLE".
Step 6: I nspect each component and subsystem of the complete system in accordance with the associated manufacturer's instructions. See section
6 for a description of the makeup of the different types of subsystem and systems.

10.3 CORRECTIVE ACTION

When inspection reveals sign of inadequate maintenance, the WORKMAN FP STRYDER must be immediately removed from service and marked
as "UNUSABLE" until destroyed or subjected to corrective maintenance. Defects, damage, excessive wear, malfunction and aging are generally not
repairable. If detected immediately remove the WORKMAN FP STRYDER from use and mark it as "UNUSABLE" until destroyed. For final disposition,
submit the WORKMAN FP STRYDER to a competent person who is authorized to perform Formal Inspection. If there is any question as to reliability,
contact MSA, or a service center authorized in writing by MSA, before further use of the device.
Only MSA or parties with written authorization from MSA may make repairs to the MSA WORKMAN FP STRYDER.

11.0 INSPECTION LOG:

Model No.: _________________________________________________ Inspector: __________________________________________________
Serial No.: _________________________________________________ Inspection Date: _____________________________________________
Date Made: _ _______________________________________________ Disposition: _________________________________________________
Comments: ____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
Page 8
CAUTION
!
© 2013 MSA