Multiplex MULTIGYRO G3 Instrucciones página 13

If the gyro system compensates in an incorrect direction, the
running direction must be altered. In this case, please follow
the instructions below:
1. Remove the jumper from MULTIGyro G3.
2. Switch on the transmitter and then your model.
3. If the blue and the red LED flash once, MULTIGyro is in reverse.
4. Reverse setting menu
a. The LEDs start to flash in a rotary pattern after one
second. The colour indicates the current gyro system
setting. Blue represents "Standard" and red "Reverse".
b. Aileron: the blue or red LED flashes once every second
– for a total of five times. While the LED is flashing,
you can change the direction of the aileron function by
moving the left-hand rudder stick to the left or right.
Hold the rudder stick in the end position until the colour
of the LED changes and the setting has been saved.
c. Elevator: the blue or red LED flashes twice every second
– for a total of five times. While the LED is flashing,
you can change the direction of the elevator by moving
the left-hand rudder stick to the left or right. Hold the
rudder stick in the end position until the colour of the
LED changes and the setting has been saved.
d. Rudder: the blue or red LED flashes three times every
second – for a total of five times. While the LED is flashing,
you can change the direction of the rudder by moving
the left-hand rudder stick to the left or right. Hold the
rudder stick in the end position until the colour of the
LED changes and the setting has been saved.
5. Change the control directions of MULTIGyro
G3
a. To change the control directions of the gyro,
move the left-hand rudder stick to the left or
right. While the LEDs are flashing, you can
toggle between the setting "Standard" and
"Reverse".
b. The LEDs continue to flash until you release
the rudder stick.
6. Exit Set-up mode
You can exit the Set-up mode at any time by
switching off the device. Remember to re-insert
the jumper in the correct slot for model type
selection.
13