Dyna-Glo DGP350SNP Manual Del Usuario E Instrucciones Para El Funcionamiento página 11

3. Insert 4 screws (A) halfway into threaded holes in
bottom shelf (1). Attach the cart left side panel (5) by
placing the panel keyholes over the screw heads (A)
on left side of bottom shelf (1). Slide the cart left side
panel (5) so that the screw head is over the smaller
part of the keyhole. Thread the screw (A) down snug
but do not tighten as a little wiggle room will be neces-
sary in following assembly steps. Repeat with cart
right side panel (6).
Hardware Used
A
M6 x 12 Screw
4. Insert one screw (A)
halfway into the middle
rear threaded hole of
each of the cart left side
and right side panels
(5&6). Attach the cart
rear panel (7) by sliding
the keyholesin the cart
rear panel (7) over the
inserted screws. Slide
the rear cart panel (7)
down to meet bottom
shelf (1). Secure the cart rear panel (7) to the
bottom shelf (1) with 2 screws (AA). Tighten
all screws, including the 4 screws in cart side
panels (5 and 6).
x4
4
5
7
1
3
5
6
A
Hardware Used
A
M6 x 12 Screw
9
A
5
6
1
x4