HEINE OMEGA 500 Guia De Inicio Rapido página 3

HEINE OMEGA
®
HEINE OMEGA
®
with LED or XHL Illumination
Please read and follow these instructions for use carefully and keep
them for future reference.
General Conditions of Warranty
Instead of the statutory warranty time period of 2 years, HEINE will grant a
guarantee of 5 years from the date of the consignment of the goods ex works,
concerning its equipment (excluding disposables, e.g. bulbs, single-use
articles, and rechargeable batteries). Date of consignment means that HEINE
hands the goods over to the transport carrier, freight forwarder or any other
person designated by the Customer for the transport of the goods without
loading the collecting vehicle.
The guarantee covers irreproachable workmanship, on condition of the proper
use of the equipment and the observation of the operating instructions. During
the warranty- and guarantee time period, errors and deficiencies arising on
the equipment will be rectified free of charge, in so far as such are evidenced
by defective materials, processing and/or constructional errors. Should buyer
complain of a material deficiency during the warranty time period, then the
onus of proof is always to be on the orderer, that the product was defective
already upon receipt of the goods. The statutory warranty and the guarantee
do not apply to loss or damage caused by wear and tear, negligent use, the
non-employment of original HEINE components and/or spares (in particular
bulbs, as these have been especially developed for HEINE instruments in
accordance with the following criterions: colour temperature, useful service
life, safety, optical quality and performance. The statutory warranty and the
guarantee do not apply to interventions by persons not authorised by HEINE
or when the operating instructions are not observed by the customer. Any
modification of a HEINE product with parts or additional parts which do not
conform to the original HEINE specification will invalidate the warranty for
the correct function of the product and further invalidate any warranty claims
which result from such a change or modification. Further claims, in particular
claims for replacement of loss or damage, which are experienced otherwise
than directly on the HEINE product itself, are hereby excluded.
For U.S. only:
Federal law restricts this device to sale by or on the order of a
Physician or Practitioner.
Warnings and Safety Information
Caution! Indicates potential hazardous situations. Ignoring the
corresponding instructions may lead to dangerous situations of mild
to moderate extent. (Background color yellow, foreground color black.)
Note! Note indicates valuable advice in terms of installation, operation,
maintenance or repair. Notes are important, but not related to hazardous
situations.
Intended Use
The indirect Ophthalmoscope HEINE OMEGA
battery powered device for medical professionals, containing illumination and
viewing optics intended to examine the media, cornea, aqueous, lens,
vitreous and the retina of the eye.
500
500 UNPLUGGED
® 500 is an AC-powered or
Product overview
1 Headband height adjustment knob
2 Adjustment knob
3 Optics unit
4 Optics overband
5 Position control
6 Filter Control
7 Aperture Control
8 Control Locks
9 Rotary knob
10 Mount for Teaching Mirror
11 Dynamic range lever
12 Bulb cover
13 Bulb (XHL or LED)
14 Brightness control HC 50 L
15 Guide pin
16 Hole for guide pin
17 Pin
18 Release
19 Detent plate
20 Guide pin
21 Cable guide
22 Headband size adjustment knob
23 Segment cover
24 HC 50 L connecting cable with UNPLUGGED socket
Setting up the HEINE OMEGA
The brightness controller HC 50 L can be used with XHL bulbs and
LED modules.
HEINE OMEGA
®
Operation with the HEINE® mPack or EN50:
To operate the HEINE OMEGA
connect the short cable (24) from the HC 50 L brightness control (14) to the
connecting cable (Cinch) and secure it in the cable guide (21). Connect the
connecting cable (Cinch) to the HEINE
the brightness on the instrument with the HC 50 L brightness control (14),
(Fig. 1).
Operation with the HEINE® mPack UNPLUGGED:
To operate the HEINE OMEGA
first remove the cover from the rear segment (23) on the headband. To do
this, slide the segment cover from the headband in the direction of the arrow
(Fig. 2). Next, fit the HEINE
this, hold the headband with your left hand and using your right thumb, slide
the HEINE mPack UNPLUGGED to the left until it latches audibly. Connect
®
the short cable (24) from the HC 50 L brightness control (14) to the HEINE
mPack UNPLUGGED. Switching on and adjustment of brightness are carried
out by means of the rotary knob on the HC 50 L brightness controller (14), (Fig. 3).
Operation with Power supply for HC 50 L brightness controller:
To operate the HEINE OMEGA
short cable (24) of the brightness controller HC 50 L (14) with the connection
cable (UNPLUGGED connector) secure it in the cable guide (21). Connect the
connecting cable (Cinch plug) with the power supply and set the brightness
using the brightness controller HC 50 L (14) on the instrument (Fig. 1).
med 1712 2013-10-02
500
®
500 can be used with HEINE LED or 5 Watt XHL bulbs.
® 500 with the HEINE
® mPack or the HEINE
500 with the HEINE
®
mPack UNPLUGGED to the headband. To do
®
500 with power supply, please connect the
®
ENGLISH
® mPack or HEINE ® EN50,
® EN50 and set
mPack UNPLUGGED,
®
®
3/20