Brod & Taylor FP-105 Manual De Instrucciones página 9

Setup and Storage
Open the lid by lifting the front edge of the Proofer. Allow the lid to rest in the vertical
position. Remove the wire rack and water tray. Lift the expanding box section from the
front edge, allowing it to remain attached to the base at the back so it can pivot
open as shown. Pull only the front wall forward to expand and fit into the grooves on
the front and sides of the base.
DO NOT Remove Folding Walls
Select the Mode for Setup
PROOFER HUMID MODE:
plate with water in the tray. Put the wire rack in next with the feet down.
PROOFER DRY MODE:
feet down.
SLOW COOK MODE:
Lift the lid straight up from the rear hinges and place onto the top of the expanded
box, fitting the guides on the lid into the matching grooves. Lower the lid to a closed
position. Plug the power cord into the Proofer first and then into an appropriate wall
receptacle.
Pre-Heat
For best results, pre-heat the Proofer for 10-15 minutes before using.
Page 4
Place the water tray in the center of the heating
Do not use the water tray. Put the wire rack in with the
Do not use the water tray or wire rack.