Getting Started; Accessory List; Turning Power On And Off; Detaching And Attaching The Front Panel - Alpine CDA-9883 Manual De Operación

Getting Started

/ /ENT
Rotary encoder
(OPEN) SOURCE/
/RTN FUNC./SETUP

Accessory List

• Head unit ............................................................................1
• Power cable........................................................................1
• Mounting sleeve.................................................................1
• Carrying case .....................................................................1
• Bracket key.........................................................................2
• Screw (M5 x 8)....................................................................4
• Owner's Manual .......................................................... 1 set

Turning Power On and Off

Press SOURCE/ to turn on the unit.
• The unit can be turned on by pressing any other button except
(OPEN) and TITLE.
Press and hold SOURCE/
off the unit.
• The first time power is turned on, the volume will start from level 12.

Detaching and Attaching the Front Panel

Detaching
1
Turn off the unit power.
2
Press (OPEN) to open the front panel.
To close the front panel, press the left side until it locks as
shown in the figure below.
6
-EN
for at least 2 seconds to turn
3
Grasp the front panel firmly, slide to the left
and then pull to remove.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it
may result in malfunction.
• Do not leave the front panel open, or drive the car with the panel
open as it may result in an accident or malfunction.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel
to avoid pushing buttons by mistake.
,