EN
5.4 STARTING A BLAST CHILLING OR DEEP FREEZING CYCLE
After selecting a blast chilling or a deep freezing cycle and pressing START
to start it, a screen like the one on the side is displayed.
In the example shown, a soft blast chilling with probe has been selected.
The indications provided in the screen are:
Type of cycle: blast chilling (icon
Control: probe (icon
Chamber temperature at the top right.
Value detected by the probe (28° large in the middle of the screen)
End of cycle value (3° smaller)
The set value can be changed by pressing the probe icon.
STOP button to interrupt the cycle.
In this other example the indications are:
Type of cycle: deep freezing (icon
Control: probe (icon
Active phase
(we remind you that a hard cycle consists of a hard deep
freezing phase, a deep freezing phase and a conservation phase).
Chamber temperature at the top right.
Value detected by the probe (28° large in the middle of the screen)
End of phase value (-5° smaller)
The set value can be changed by pressing the probe icon.
STOP button to interrupt the cycle.
) soft
)
) hard
)
26