American Standard Advanced Clean 100 Combo Manual Del Usuario página 33

Useful Information
®
The water in the SpaLet
significantly low.
Perform the following procedure to prevent freezing and related damage.
Do not disconnect the power plug from the outlet. Leave the power turned on. Turn off any active power save function.
If the bathroom can be heated:
If the bathroom cannot be heated:
CAUTION
Make sure to follow one of the
freezing prevention procedures
whenever there is a possibility of
OBSERVE
freezing.
* Damage from freezing may cause fire
or flooding.
General Freezing Prevention Procedure
1 Set the 【Seat Temp.】 to "High" and close the SpaLet lid
( ☞ Page 9).
2 Turn off any active power save function ( ☞ Page 21).
3 Heat the bathroom.
Intermittent Flushing to Prevent Freezing
1 Set the 【Seat Temp.】 to "High" and close the SpaLet lid
( ☞ Page 9).
2 Turn off any active power save function ( ☞ Page 21).
3 Press and hold both the 【Massage】 and 【Nozzle
Cleansing】 buttons for at least 2 seconds.
* Each pressing of these buttons will turn the function on and off.
* Flush the SpaLet every 6 minutes to prevent freezing.
* Water consumption with this method is approximately 960 L/254 gals
in a 24 hour period.
may freeze and cause damage during winter or other times when the water temperature is
Refer to the "General Freezing Prevention Procedure" section.
Refer to the "Intermittent Flushing to Prevent Freezing" section or
"Draining the Water to Prevent Freezing" section.
【 Seat Temp. 】
【 Massage 】 + 【 Nozzle Cleansing 】
30 - EN