Troubleshooting
Flushing the SpaLet (Continued)
Symptom
Blocked debris
The SpaLet flushes
automatically.
There does not
appear to be much
difference between
full flushing and
partial flushing.
The noise when
flushing the SpaLet
is louder than
before replacing
the seat unit
Auto Seat Open and Automatic SpaLet Seat Open/Close
Symptom
SpaLet seat or
SpaLet lid closes
forcefully making
a noise.
The SpaLet lid or
SpaLet seat does
not automatically
open or close.
51 - EN
Cause
Large quantities of toilet paper
have been used.
The intermittent flushing function is
turned on.
This is not a malfunction.
Full flushing uses approximately 1 L/1.1 Qt. more water than partial
flushing, which makes it difficult to see a difference. Additionally, there is
no major difference in the time required for flushing. Please continue use.
The design differs to the product before replacement. For this reason,
noise may seem louder than before.
Cause
The SpaLet lid was pressed during
the automatic opening or closing
process.
A third-party SpaLet seat lid cover
or SpaLet seat cover is too heavy
or stuck.
The power plug is not connected to
the power outlet.
The auto seat open function is
turned off.
A third-party SpaLet lid cover is too
heavy or stuck.
The SpaLet lid is not attached
correctly.
Solution
Close the water shutoff valve and
then remove the blockage.
* Automatic flushing may occur
unintentionally causing water to
overflow from the SpaLet
Turn off the intermittent flushing
function.
Solution
If the automatic open or close
operation does not start even after
pressing the 【Open/Close SpaLet
Seat】 button again, disconnect the
power plug from the outlet and
have the SpaLet serviced.
Use the SpaLet without a SpaLet
seat lid cover or SpaLet seat cover.
Completely connect the power plug
to the outlet.
Wait about 10 seconds before
reconnecting the power plug.
Turn on the auto seat open function.
Please use the SpaLet without a
SpaLet lid cover.
Attach the SpaLet lid correctly.
Page
ー
®
bowl.
30
ー
ー
Page
ー
ー
7
18
ー
36