Front And Rear Washing - American Standard Advanced Clean 100 Combo Manual Del Usuario

General Operation
STEP
3

Front and Rear Washing

Rear Washing - Mild
Front Washing
1 Press the 【 Cleansing (Full) 】 button,
【 Cleansing (Partial) 】 , or 【 Bidet 】 button.
Rear washing functions wash any waste still remaining after a bowel movement.
Rear washing
Rear washing - mild : Sprays water with less pressure for a more gentle wash
Front washing functions wash any waste remaining during menstrual cycles or other circumstances.
Keep washing times between 10 to 20 seconds.
Rear washing/Rear washing - mild
(Press once)
The nozzle spray will
discharge from the nozzle
tip to wash your rear.
Front washing
(Press once)
The nozzle spray will discharge
from the nozzle tip to wash the
delicate areas of women.
3 Press the 【 STOP 】 button to
stop operation.
®
* This SpaLet is equipped with an auto-stop function
so that rear washing and rear washing - mild operation
stops automatically after 2 minutes. Note that operation
can be extended by an additional 2 minutes when other
operations are performed while washing operations are
ongoing, such as the massage and oscillating spray
functions, for a total of 6 minutes maximum of washing
before automatically stopping.
Oscillating Spray
Wide Washing
: Sprays water to wash
Wide washing
(Press twice)
The nozzle will move
back and forth to clean
over a wider range.
Wide washing
(Press twice)
The nozzle will move
back and forth to clean
over a wider range.
Super Oscillating Spray
Oscillating Spray - Super
Super oscillating rear washing
(Press three times)
The nozzle will move back and forth
rapidly to wash more thoroughly.
* Press 4 times to cycle back to Rear
washing/Rear washing - mild.
Oscillating spray - super
(Press three times)
The nozzle will move back and forth
to clean over an even wider range.
* Press 4 times to cycle back
to front washing.
2 Press the 【+】 or 【－】 sides of
the Spray Strength button to
adjust the spray strength.
* There are 6 levels of spray strength available.
Start with a low setting and then gradually
increase the strength until the desired pressure is
reached.
* To increase pressure: Press the [+] side of the button.
To decrease pressure: Press the [-] side of the button.
14 - EN