iSi THERMO XPRESS WHIP Modo De Empleo página 25

English
ChARGING
4.
Insert the assembled riser tube (with bottle gasket attached) into the stainless steel bottle.
5.
Screw the device head (with push button attached) onto the stainless steel bottle so that it is straight
and sealed tightly.
WARNING Never attach the device head so that it is crooked.
6.
Insert 1 original iSi cream charger into the charger holder as shown in figure 6.
7.
Screw on the charger holder (with charger inserted) to the device head until you hear all of the
contents of the charger release into the bottle.
WARNING Never lean your body over the device when screwing in the charger.
WARNING The device is now pressurized.
8.
Vigorously shake the device.
NOTE: The required number of shakes is important for achieving the optimum consistency for your
preparation. Overshaking or shaking the device too many times will cause the contents to solidify and it
won't be possible to dispense all of the content from the bottle.
25