iSi THERMO XPRESS WHIP Modo De Empleo página 35

English
► G as escapes between the bottle and the head during charging
There is no bottle gasket
▪ "Release pressure" (page 32). Insert the bottle gasket with riser tube.
The bottle gasket has been damaged
▪ "Release pressure" (page 32). Replace the bottle gasket.
The head was not screwed on securely enough
▪ Screw the head onto the bottle in accordance with the instruction manual so that it is straight
and sealed tightly.
Bottle has been damaged on the upper edge
▪ "Release pressure" (page 32). Send the device to the iSi service center.
► T he content leaks when the device is charged
It is difficult to press the push button
The push button has not been screwed on to the device head securely enough
▪ Screw the push button on to the device head until it no longer turns.
► I t is difficult to screw on the charger holder
The charger used is not compatible
▪ Only use original iSi cream chargers.
There is too much resistance between the threads of the charger holder and piercing unit
▪ Regularly oil the charger holder thread (common oils such as sunflower or olive oil should be used).
35