Reverse Operation; Bit Replacement - Senco DURASPIN DS222-18V Instrucciones Para La Operación

CAUTION
when the battery is low, or the drive requires too much torque, the tool may stall at
the bottom of the drive (before the clutch can disengage). the same procedure should be followed
as mentioned above for tool cut-out.

reVerSe oPerAtioN

WARNING
to prevent the feed system from unintentionally falling off the tool, ensure the locking
collar is at the locked position before starting to drive screws or when carrying tools.
to operate tool in reverse for removal of screws (see Figure 1):
1. Flip the forward/reverse switch to the right for reverse rotation.
2. turn the locking collar on the detachable feed system to the unlock position.
Locked
3. Slide the feed system off the tool to expose the bit.
4. insert bit into screw and apply/maintain pressure to engage clutch.
5. Pull trigger until screw is completely disengaged.

Bit rePlAceMeNt

Due to wear or damage, the bit will need to be replaced periodically or when changing between drive
types.
the bit can be removed/replaced in two ways:
1. without removing feed system
i. remove fasteners from the tool.
ii. Slide bit release button to rear.
iii. tilt tool forward and pulse trigger.
iv. Bit will fall out.
v. Hold tool upright.
vi. insert the new bit into the slide body.
vii. Slide bit release button to rear.
viii Pulse tool and release button when bit drops into place.
2. removal of tool front end/feed system
i. turn the locking collar on the detachable feed system to the unlock position.
ii. Slide the feed system off the tool to expose the bit.
iii. Slide bit release button to rear.
iv. Pull the old bit out and release button.
v. insert the new bit into the bit retainer and push until it clicks into place.
(Slight rotation of the bit may be necessary for proper alignment and full insertion.)
vi. install feed system and rotate collar to lock position.
tool oPerAtioN
Unlocked
11