Light ON/OFF
The cookerhood light can also be switched on by lowering the bottom openable panel as
shown in fi gure G2.
The motor starts with speed 1, when the openable panel (PA) is lowered.
Button -
By pressing the key the motor speed reduces.
Speed 1, 2 and 3 is displayed by the number of LEDs switched on, excluding the light and
timer LEDs.
Button +
By pressing the key the motor speed increases.
Speed 1, 2 and 3 is displayed by the number of LEDs switched on, excluding the light and
timer LEDs.
(In the 4 speed version the + key shows an intermittent light. The 4th speed or intensive
setting is timed and after about 7 minutes the motor automatically switches to 3rd speed).
IMPORTANT NOTE: the cookerhood is fi tted with a micro-switch that disables the motor
operation with the sliding panel closed (see fi g. G2).
Mode button
Function: cookerhood motor switch-off and switch-on.
The desired speed function enables starting the motor with the last speed selected prior to
switch-off.
Filters saturation and timer button
• This function enables the automatic switch-off of the cookerhood after 15 minutes of
functioning at previously set speed (button with intermittent light).
• After about 30 hours of operation, the button reminds you to wash the metallic fi lters (red
lit button). To deactivate the alarm, press the timer button for a few seconds until the red
light switches off. Subsequently switch-off the cookerhood and switch it on again to verify
the cancellation of the alarm.
H
FILTERS
1 METAL FILTERS
Open the sliding panel (PA) and remove the fi lters as shown in fi gure H1 to extract the
metal fi lter.
2. CARBON FILTERS
Loosen the V4 screws as shown in fi g. H2 to replace the active carbon fi lters.
For new fi lters, tighten fl ange P to the fi lter using the two V3 screws provided.
To order new carbon fi lters contact your distributor/dealer.
ONLY FOR ITALY: Download the form to order the filter from the website: www.falmec.com.
REMOVING AND REPLACING'S INSTRUCTIONS