Interface Installation - OHAUS T24PE Manual De Instrucciones

RS232 Interface
INTRODUCTION
This RS232 kit is for use with the T24PE Indicators.
KIT CONTENTS
 RS232 PCB
 RS232 Interface Cable
 Screws (1)
 Instruction Manual

INTERFACE INSTALLATION

CAUTION: Observe the following precautionary measures to avoid
personal injury or damage to the equipment.
- Disconnect the equipment from the mains power supply and internal battery before beginning
the installation process.
- Use electrostatic protection measures when handling the printed circuit boards.
- Installation should only be performed by qualified personnel.
1. Disconnect the power supply and load cell cables from the indicator.
2. Remove the 4 screws on the bottom of the indicator and open the enclosure.
3. Remove the plastic cover by pushing it out with a screwdriver or similar object.
EN-1