ESAB SMASHWELD 316 Manual De Instrucciones página 32

8) MAINTENANCE
In normal environment and operation conditions the Smashweld 316 and Smashweld 316 Topflex, do not
require any maintenance or special service. It is enough to clean it inside once every two month with low
pressure compressed air, dry and free from oil.
After cleaning the equipment with blow dry air, check that the electric connections and components are
properly fixed. Check for possible faults in the wire isolations or electric cables, including the welding cable
and any others and if any of them is faulty substitute it.
The exhauster refrigeration motor can, after some time, damage, its substitution is simple and its repair
follows usual procedures for industrial motors. If overloaded by lack of refrigeration or use of the unit in
conditions not predicted by ESAB, the rectifier bridge can be damaged, opening itself or suffering a short
circuit. In this case, the empty voltage is lower that what is indicated in the scale, the rectifier bridge should
then be substituted.
9) REPAIR
In order to ensure the perfect functioning and performance of ESAB equipment, use only original parts
supplied by ESAB or approved by them. All guarantee undertakings from the supplier cease to apply if the
customer uses non-original or non -approved parts when replacing any of them.
Spare parts can be obtained from the ESAB Authorized Services or from its Sales Distributors listed on the
last page of this Manual. Always inform the Equipment Model and Serial Number of the equipament in
question.
10) OPTIONALS
10.1) Welding guns
TABLE 10.1
Description
MXL 200 3 m
MXL 270 3 m
MXL 340 3 m
32
Smashweld 316
Smashweld 316 Topflex
A T E N T I O N !
Never operate the voltage adjustment switches during
welding to avoid damaging them.
Duty cycle CO
2
200 A / 35%
270 A / 35%
340 A / 35%
Duty Cycle Mixtures
170 A / 35%
260 A / 35%
320 A / 35%
Wire - Ø mm P/N
0,6 - 1,0 0905980
0,8 - 1,2 0905981
0,8 - 1,2 0905982