Switching Off The Adaptive Torque Module; Basic Operation - Hilti SI­-AT-­A22 Manual De Instrucciones Original

2. Press the control switch on the impact wrench briefly.
◁ The display illumination switches on and shows the start screen briefly
(
◁ The indicator LEDs light red for 1 second as a check and then green
for 1 second.
◁ The last previously selected operating mode is shown in the display in
a selection frame.
▽ An error/message is shown in the display.
▶ Refer to the "Troubleshooting" section for information about the
possible causes of error messages and the steps to be taken to
remedy the problem.
3. Press the lock button.
◁ The torque module is now locked and the impact wrench is ready for
use.

5.3.2 Switching off the adaptive torque module

The adaptive torque module switches itself off automatically:
• when the impact wrench switches off automatically after a long idle period
• when the battery is removed
• when the USB connection between the torque module and the PC is
interrupted (one of the USB connectors is unplugged).

5.4 Basic operation

Note
In this section, the most frequently used basic functions are explained
in order to illustrate how the module is used.
A detailed description of certain operations can be found in the section
covering specific applications.
Unlocking the module
In order to change the settings on the adaptive torque module, the module
first has to be unlocked.
▶ If you wish to unlock the adaptive torque module, press and hold the
lock button for at least 3 seconds.
◁ In the display a selection frame appears around the last previously
shown type of fastening and the last previously shown operating mode.
◁ The torque module is unlocked and in setting mode. The impact wrench
is deactivated.
Navigation
When the selection frame and several elements (options, parameters) are
shown in the display, the selection frame can be moved by pressing the
arrow buttons and
6 English
Printed: 10.02.2017 | Doc-Nr: PUB / 5331558 / 000 / 00
).
.