Hilti SI­-AT-­A22 Manual De Instrucciones Original página 16

Note
When the "Adaptive" operating mode is selected, the "AT" torque
indicator lights in the display on the impact wrench. The torque selector
switch on the impact wrench is then inactive and the impact wrench's
control switch simply has an ON/OFF function.
Parameters in adaptive operating mode
Type of tightening operation
@
(short name for fastener)
Material grade / quality
;
Diameter
=
The illustration shows the positions of the operating parameters shown in
the display.
Type of threaded fastener
Factory-set parameters for various types of threaded fastener have been
saved in memory in the torque module.
Note
The list below can vary from country to country, so the threaded
fasteners listed should be considered as examples only.
The parameter settings published for the fasteners can change; the
software in the torque module must therefore be kept up to date at all
times.
Indication in the dis-
play
KB...
Material grade / quality
Indication in the dis-
play
— (display stays
blank)
SS304
SS316
Diameter
The following diameters can be selected as standard:
• 3/8"
• 1/2"
• 5/8"
10 English
Printed: 10.02.2017 | Doc-Nr: PUB / 5331558 / 000 / 00
Meaning
KB... stud anchor
Meaning
Galvanized steel
Stainless steel, 304 grade
Stainless steel, 316 grade