Checking Bolted Connections Made Using The "Bolting" Operat- Ing Mode - Hilti SI­-AT-­A22 Manual De Instrucciones Original

Anchor diameter
(Ø)
≥ 1/2"
Result 1 / 2
The fastening element was not turned further than through the specified
maximum angle of rotation (α).
Installation of the threaded fastener undertaken in the "Adaptive" operat-
ing mode was performed correctly; the specified installation torque was
achieved.
Result 2 / 2
The fastening element was turned further than the specified maximum
angle of rotation (α).
Installation of the threaded fastener undertaken in the "Adaptive" oper-
ating mode is faulty, because the specified installation torque was not
achieved. The threaded fasteners tightened since the previous check are
to be regarded as faulty and must be checked. The impact wrench must
be checked by Hilti Service.
5.10.2 Checking bolted connections made using the "Bolting" operat-
ing mode
▶ At regular intervals, use a suitable torque wrench in accordance with the
manufacturer's instructions or specifications, to check that the nominal
torque has been achieved.
5.11 Removing the battery
▶ Remove the battery (→ SIW 6AT­A22 operating instructions).
5.12 Removing the torque module
1. Remove the battery. → page 17
2. Press the release button on the torque module and hold it in this position.
3. Pull the torque module away from the impact wrench to the rear.
5.13 Connecting the torque module to a PC
1. Remove the torque module. → page 17
2. Open the sliding cover on the underside of the torque module.
◁ The USB socket is then accessible.
3. Plug the connector on the USB cable (type B, USB 2.0) into the USB
socket on the torque module.
4. Plug the other connector on the USB cable (type A) into the PC.
◁ The PC then supplies power to the torque module. The USB logo
is shown in the display on the module.
Printed: 10.02.2017 | Doc-Nr: PUB / 5331558 / 000 / 00
Maximum angle of
rotation (α)
180°
7
8
English 17