Symbol Function; Setting The Signal Tone Volume Or Display Brightness And Con Trast - Hilti SI­-AT-­A22 Manual De Instrucciones Original

Symbol Function
Show the date and time set in the torque module
Note
The clock can only be set using the PC software
PROFIS Adaptive Torque.
Show the remaining time / period of use until servicing of the
impact wrench is again due
Show the amount of memory used in the torque module
Note
When the value indicated reaches 100%, the oldest data will
be overwritten.
The PROFIS Adaptive Torque PC application can be used
to read the recorded data and to delete data from memory in
the torque module.
Show the software version installed in the torque module
Leave the basic settings menu
2. Press the OK button.
5.5.3 Setting the signal tone volume or display brightness and con
trast
Note
The settings for volume, brightness and contrast are made in the same
way. Accordingly, as an example, only the setting of the brightness and
contrast is described in the following paragraphs.
1. Press the right or the left arrow button to set the desired brightness /
contrast level.
◁ The number of black rectangles indicates the level selected (in the
illustration above: level 3).
◁ When level 0 is reached the symbol
backlighting is switched off.
2. Press the OK button.
◁ The basic settings menu is shown again.
8 English
Printed: 10.02.2017 | Doc-Nr: PUB / 5331558 / 000 / 00
changes to indicate that the