Setting The Operating Mode By Way Of The Control Panel Buttons - Hilti SI­-AT-­A22 Manual De Instrucciones Original

Scanning the bar code or QR code
If a bar code or a QR code is available for the Hilti product to be tightened,
the operating mode can be set correctly for the product quickly and easily
by scanning the code.
▶ Set the operating mode by scanning a bar code or QR code. → page 13
Manual settings
If no bar code or QR code is available for the product to be tightened, the
operating mode can be set by way of the buttons on the torque module.
Note
The "Unregulated" operating mode can only be set manually.
▶ Use the buttons to set the operating mode. → page 13

5.7.1 Setting the operating mode by way of the control panel buttons

1. Unlock the torque module. → page 6
2. Use the arrow buttons to move the selection frame, as necessary, onto
another option that you wish to change.
3. Press the OK button.
◁ The selected option is then shown highlighted in black.
4. Use the arrow buttons to select the desired setting.
5. Press the OK button.
◁ The selected setting is again shown in the selection frame.
6. If necessary, repeat the last 3 steps to make further settings.
7. Lock the torque module. → page 6
5.7.2 Setting the operating mode by scanning the bar code or QR
code 6
1. Unlock the torque module. → page 6
2. Press the scan button.
◁ The scanner is activated and readiness for scanning is indicated in the
display by the
3. Now hold the module so that it faces the bar code or QR code at a
distance of approx.. 15 centimeters (6"), so that the code is within the
frame projected by the scanner.
◁ The indicator LEDs light green.
◁ The confirmation tone is emitted (can be deactivated in the basic
settings).
◁ The operating mode for the product to be tightened is shown in the
display.
▽ The indicator LEDs light red.
▽ The warning tone is emitted (can be deactivated in the basic settings).
Printed: 10.02.2017 | Doc-Nr: PUB / 5331558 / 000 / 00
symbol.
English 13