Basic Settings; Displaying The Basic Settings Menu; Selecting Functions From The Basic Settings Menu - Hilti SI­-AT-­A22 Manual De Instrucciones Original

Selecting options / changing parameters
When the torque module is unlocked, options or parameters can be adjusted
as follows:
▶ Position the selection frame in the display on the element (option /
parameter) that you wish to change.
▶ Press the OK button.
◁ The element will be highlighted.
▶ Use the arrow buttons to make the desired setting.
▶ Press the OK button to accept the setting shown.
◁ The element is again shown in the selection frame.
Locking the module
After all settings have been made, the adaptive torque module must be
locked again.
▶ Press the lock button
◁ The selection frame disappears from the display.
parameters that have been set are now saved and cannot be changed
accidentally.
◁ The adaptive torque module is locked and the impact wrench activated
again.

5.5 Basic settings

5.5.1 Displaying the basic settings menu

1. If the torque module is locked, unlock the torque module by pressing and
holding the lock button for at least 3 seconds.
2. Press the OK button and hold it in this position for at least 3 seconds.
◁ The basic settings menu is shown.

5.5.2 Selecting functions from the basic settings menu

1. Use the arrow buttons to move the selection frame to the symbol for the
desired function.
Functions in the basic settings menu
Symbol Function
Set the volume of the signal tone or switch the tone on / off
Set the brightness and contrast of the display
Printed: 10.02.2017 | Doc-Nr: PUB / 5331558 / 000 / 00
.
The operating
English 7