Speed Levels; Controllable Functions - LGB 28440 Manual Del Usuario

Speed Levels

This decoder can be operated with 14 or 28/128 speed levels (CV 29, Bit 1). Make sure
that the setting on the decoder is compatible with the settings on your controller.
Long Address
This decoder can be controlled in DCC by means of a short (CV 1, address 1 – 127)
or a long address (CV 17 & CV 18, address 1 – 10239). Both addresses are basically
always occupied. CV 29, Bit 5 is used to determine which of the two addresses is
currently valid.
The settings for the long address are calculated as follows:
X = Address / 256 (only the whole number part)
CV 17 = X + 192
CV 18 = Address – (X x 256)
Example:
Address 1324
X = 5 (1324/256=5,17)
CV 17 = 197 (5+192=197)
CV 18 = 44 (5*256=1280; 1324-1280=44)

Controllable Functions

Lighting *
Sound effect: whistle blast
Sound effect: Squealing brakes off
Raising/lowering pantographs, sequence **
Sound: Greeting announcement
Sound: station announcements, sequence for (RhB) Chur - Arosa
Sound effect: Operating sounds *
Raising/lowering pantographs, direction-dependent *
Sound on/off
ABV, off
Sound effect: Short whistle blast
Sound effect: Blower
Sound: vacuum pump
Sound effect: sanding
* active in analog operation
** is turned off by Function 7
Note:
At www.LGB.de, you will find at „Tools and Downloads" an extensive description of
the decoder as well as a tool that you can use to calculate different settings.
13
LV + LR
1 Sound 1
2 BS
3 Sound 15
4 Sound 7+9
5 Sound 10
6 FS
7 Sound 16
8 Sound 8
9
10 Sound 2
13 Sound 4
14 Sound 3
15 Sound 5