QSC PLD Guia De Inicio Rapido página 8

Preset Wizard
The Preset Wizard simplifi es the preset creation process, and allows you to create a preset from the ground up. The Preset Wizard provides a
mechanism for you to select the desired power and load. Based on these selections, the best amplifi er confi guration is selected and you are then
allowed to select and assign loudspeakers to each output.
HOME > PRESETS > PRESET WIZARD > ENTER
STEP 1 — About the PRESET WIZARD
ABOUT
Preset Wizard does the following:
• Configures the amplifier
• Loads DSP settings for assigned speakers
Tips:
• Start with the highest power
• Speakers do not need to be assigned
to each output
STEP 2 — Adjust Impedance and Power
EN
OUTPUTS
Output:
Imped:
Power:
Remaining Power Available: 1875 W
Enter Load Profile (Impedance and Power)
HOME > PRESETS > PRESET WIZARD > ENTER > (ENTER)
Possible Output Mode Combinations using the Preset Wizard
A B C
- - - - - - - - -
*
25% 25% 25%
*Percentages are used to represent the power for different amplifi er models.
STEP 3 — Select Output Channel for Speaker Assignment
OUTPUTS
Output:
Imped:
Power:
Spkr:
TD-000351-00-D
SPEAKERS SAVE
NEXT
SPEAKERS SAVE
A B C
8.0 - - - -
625 - - - -
D AB C D AB
- - - - - - - - - - - - - - -
25% 50% 25% 25% 50%
Modes: A B = Separate Channels / A+B = Bridge Mode / AB = Parallel Mode
SPEAKERS SAVE
A B C
8.0 8.0 8.0
625 625 625
- - - - - - - - - - - -
Assign Assign Assign Assign
Preset Wizard does the following:
• Confi gures the amplifi er
• Loads DSP settings for
assigned speakers
Tips:
• Start with the highest power
• Speakers do not need to be
assigned to each output
Adjust Impedance based on the total
loudspeaker load connected to the
D
channel.
Default = 8 
- -
Default = min. for amp
- -
Impedance and Power are dynamically
linked for adjustments.
CD A+B C D A+B
- - - - - - - - - - - - - - -
50%
50% 25% 25% 50%
— Figure 15 —
When you are fi nished setting
the Impedance and Power for
D
each output, continue to scroll
8.0
to access the SPEAKERS tab.
625
Loudspeaker assignment is
- - - -
optional, you can assign a
loudspeaker to one or more
channels, or none at all.
8
To Continue, press
Scroll to select (Impedance or Power)
Turn to adjust parameter
To confi rm, press
Repeat for remaining
output channels
C+D ABC D AB + CD
- - - - - - - - - - - -
50% 25%
75% 100%
Scroll to select the Output channel.
To Assign a loudspeaker, press
Continue to the next Step.
ENTER
To edit, press
ENTER
ENTER
ABCD
- - -
100%
ENTER